I was actually involved in the design and implementaion of the roll-to roll cutters, and built the first vinyl cutters Allen ever made in 1990. The 1036 is still supported, and is a great machine. Allen Datagraph never folded at all, just was bought out by another party and renamed Allen Datagraph Systems, Inc., hence the ADSI. The background material should be smooth paper, vinyl or coated TYVEK.Just to give you a little background on ADSI, Allen Datagraph was started in 1980 by Richard Allen. If satisfactory results are not produced, you may need to slow the speed down, replace / refill the pen, or lightly sand the nib. A speed of 25 cm/s (10 inch/sec) should produce satisfactory results on most surfaces. The suggested range of speed for wide marker pens is from 8 to 30 cm/sec (10 to 45 on the Control Panel) depending on the type of material and the amount of ink left in the pen. Pen speed and proper background material are critical elements to a good plot. If the stroke is not smooth, adjust the height or lightly sand the face of the tip. Test a stroke of the pen by pushing TEST. Align the pen so that rectangular tip is perpendicular to the fill lines of the marker. Wide Marker Drawing Wide marker drawing is done in the Draw mode. Adjust the height of the wide marker in the holder vertically so that it is about 1/8 inch (3mm) above the material. Install the wide marker holder using the same hex screws. Pen Type Speed Force Felt tip 40-50 10-20 Roller Ball 40-50 30-50 Drafting 30-40 8-12 Wide Marker Holder Mounting the Optional Marker Holder The marker holder is mounted by first removing the knife tool holder block (two hex head screws). Drafting pens are held in the tool holder block or the wide marker block. Speed and force requirements vary for these pens and a chart is provided for your reference. HP style pens used by the 230 and 315 are available as drafting, felt tip and roller ball type. offset too low 16Īllen Datagraph 230/315 Vinyl Cutter Plotter Pens In the Draw Mode, the 230 and 315 are high performance drafting plotters capable of producing professional architectural and engineering drawings. If a good test pattern cannot be achieved in this manor, inspect the knife blade and replace as necessary. In that case, try an offset of 14 (or more). If the blade offset is too low, the corners will be rounded and the circles will have nicks. For example, if the original offset is 12 and the output shows signs of too much offset, try an offset of 10 (or less). If the blade offset is too high, the corners will be extended and the circles will have bumps. If the corners of the test pattern (or lettering) have misshaped corners when knife cutting, adjust the knife offset using the Allen Remote Panel Program. To make the test pattern, load material with the LOAD button and then press the TEST button. The material carrier should be marked lightly and evenly. The cutter should produce a test pattern which has accurate corners, smooth curves and is easy to "weed" out. Repeat the test as necessary to check blade quality, fine tune force, offset and blade depth. The pattern can be positioned with the joystick buttons when the cutter Load light is on and pause light off. offset correct offset too high Cut Test Pattern A test pattern is provided to verify cut quality. Change CUT and DRAW modes with the Allen Remote Panel program. If pen plots have the characteristic of the knife path, it is likely that the cutter is in the CUT MODE. Allen Datagraph 230/315 Vinyl Cutter Knife Offset This figure shows the path the pen takes and the path the knife takes at a corner.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |